LED显示屏防静电措施
LED display anti-static measures
对使用静电敏感电路人员进行静电知识和有关技术的培训。
Training on electrostatic knowledge and related technology for personnel using electrostatic sensitive circuits.
建立防静电工作区，在该区内使用防静电地板，防静电工作台，防静电接地引线以及防静电器具，并将该去相对湿度控制在40以上。
Establish anti-static work area, use anti-static floor, anti-static work table, anti-static grounding lead and anti-static equipment in the area, and control the relative humidity above 40.
静电对电子设备所造成的危害可能放生在从制造商到野外设备的任何地方。危害是由于没有充足，有效的训练和设备操纵失灵而引起的。LED是对静电敏感的设备。INGAN晶片通常被认为是“第一位”易受干扰的。而ALINGAP LEDS SHI “第二位”或更好的。
Electrostatic hazards to electronic equipment can be released anywhere from the manufacturer to the field equipment. The hazard is caused by insufficient and effective training and equipment operation failure. LED is a static sensitive device. InGaN chips are often considered "first" to be susceptible to interference. And AlInGaP leads Shi "second" or better.
ESD被损坏的设备能显示出暗淡，模糊，熄灭，短的或低VF或VR。ESD被损坏的设备不应不电子过载相混淆，如：因错误的电流设计或驱动，晶片挂接，电线屏蔽接地或封装，或普通的环境诱导压力等。
ESD damaged equipment can show dim, fuzzy, out, short or low VF or VR. ESD damaged equipment shall not be confused with electronic overload, such as: due to wrong current design or drive, chip hanging, wire shielding grounding or packaging, or ordinary environmental induced pressure, etc.
ESD的安全和控制程序：大多数电子和电光学公司的ESD非常相似，并已经成功实现了所以设备的ESD控制，操纵和主程序。这些程序因为ESD远古已经用于检测质量效果的仪器。ISO-9000认证也把他列如正常控制程序。
ESD safety and control procedures: most electronic and electro-optical ESD companies are very similar, and have successfully realized the ESD control, operation and main procedures of all equipment. These procedures because ESD has been used to detect quality effects of instruments in ancient times. ISO-9000 certification also lists it as a normal control procedure.